← Back to all work  /  Solar Water Heater
Renewable Energy Engineering Academic Team Project

Solar Water Heater

An academic engineering team project focused on designing and assembling a rooftop solar water heating system with three evacuated tubes, a 30 L storage tank, and a polished aluminium reflector.

Objectives

  • Build a practical solar water heating unit using evacuated-tube collector technology.
  • Understand how feed pressure, non-return valves, safety relief, and thermal storage work together in one loop.
  • Practice real fabrication, piping assembly, and teamwork on a physical engineering rig.

How the collector works

Each evacuated tube consists of two concentric borosilicate glass cylinders with a vacuum sealed between them. Because air is removed from the gap, heat collected by the dark selective absorber coating cannot easily escape by conduction or convection.

Water circulates between the heated tubes and the 30 L insulated tank above them, while a curved polished aluminium sheet below the tubes redirects sunlight that passes through the gaps onto the underside of the glass.

Note: This is a technical description of the system built, not claimed laboratory test benchmarks.

Interactive component map

Click any numbered pin on the annotated photograph or select a part below to inspect its role and Arabic label.

Annotated rooftop solar water heater showing all ten components labeled in Arabic

Evacuated tubes

Engineering considerations

  • Reflector alignment: geometry and spacing beneath the tubes directly influence how much diffuse and gap sunlight reaches the absorber.
  • Thermal retention: minimizing tank losses and backflow keeps water usable past peak sun hours.
  • Field assembly: accessible threaded fittings, valves, and sturdy frame bracing make rooftop setup safer and maintainable.
My contribution: I participated as a team member in developing, assembling, and documenting this project.

Rooftop photo archive

Click any pinned photograph to view the full uncropped image.